Edsal HDL183672 Steel Freestanding Shelving Storage Rack, 36" Width x 72" Height x 18&#03

• Standing five-shelf unit made of steel to support a 240-lb. per shelf capacity and to support a 1200-lb. total capacity
• Corner post holes are punched at 1-1/2" intervals for precise adjustment to shelf height
• Gray enamel finish resists corrosion
• Cross-braces on back, and braces on sides and front of unit for rigidity
• Nut and bolt assembly, instructions and nuts and bolts included, tools for assembly sold separately

Should of listened to the other reviewers on here. The shelves came bent to h*ll. they were bent so bad they were unusable. Ended up going with a different setup. Also looking at the quality of the shelves I couldn't see as flimsy as they were putting a heavy load on them. Avoid this item.

Buy Edsal HDL183672 Steel Freestanding Shelving Storage Rack, 36" Width x 72" Height x 18 Now

Good shelves for the price. We ordered two and the second one was all bent and beat up. Going to use them

Read Best Reviews of Edsal HDL183672 Steel Freestanding Shelving Storage Rack, 36" Width x 72" Height x 18 Here

the shelves came bent to hell and it added an extra hour to the job. several of the holes wouldn't line up. would not buy again.

Want Edsal HDL183672 Steel Freestanding Shelving Storage Rack, 36" Width x 72" Height x 18 Discount?

We ordered three of these metal shelving units for our basement. Did not need anything pretty and they were inexpensive. I can see why. It took two people and about an hour to assemble one shelf. Do not try it yourself. Once the frame was put together each shelf was a challenge. Sometimes the shelf needed to be bent a little to make the bolt go through and then it was a struggle to get the nut on. Magnetic Phillips is a must have tool. The manufacture design cuts a small square in each shelf corner for the bolt, but that hole does not always line up with the bolt hole in the frame. Sometimes we just gave up and used metal clippers and clip the metal off the square area so a bolt could go through. Then sometimes we had to put the bolt in backwards to make it easier to get the nut on, but now the bolt end sticks out. Some bending and twisting and pounding with a mallet was required. Once the side and back braces were put on the thing finally straighten out some. Finally it straightened out once it was attached to the wall for safety. By the time we came to the third shelf, the box was crushed on one side and we were unable to use any of the shelves. I contacted the given email at Edsal and they were very nice and sent five new ones that arrived in better condition. So I would not recommend buying these shelves unless you like a challenge, have patience and the tools. Next time I will spring for more expensive easer shelves like the Gorilla brand.

Save 30% Off

All the three sets of the product arrived with the shelve ends bent. I contacted the company requesting a replacement set so that I could complete the three sets I purchased with parts from it, however instead of recognizing the fact that I was trying to work with them and just send another set, they (the company) asked for pictures of each of the damaged components....frustrating.

I was able to cobble together three sets with the few pieces they sent, ( not all I requested to boot) but I do have extensive experience working metal. The average person would have a hard time with the product if received in the condition I did. Caution; sharp edges on some of the components.

In retrospect I should have returned their junk and demanded a full refund.